INNOCLICKER

Modular clamping for every workpiece

Clamp every workpiece in your production flexibly and fully automated with the INNOCLICKER

Flexible clamping device with rapid provisioning time

Slide title

INNOCLICKER clamps gearbox cover

Button
Slide title

INNOCLICKER clamps 3D-printed wheel carrier

Button
Slide title

INNOCLICKER clamps structural part

Button
Slide title

INNOCLICKER clamps several components

Button

Flexibly suited for any workpiece

With our INNOCLICKER clamping system you clamp all workpieces of your production with only one system.

The modular design of the system enables you to be flexible and you can reuse all hydraulic components for other workpieces.

Innoclicker modular clamping system and components exploded view

Modular design

The INNOCLICKER clamping system consists of three different units: The supply station, the clamping plates and the hydraulic clamping modules.

All elements have mechanical connectors and can be combined in various ways with a "click". This allows you to convert the INNOCLICKER for another workpiece of your production in a few minutes.

Slide title

1. Blank of a clamping plate

Button
Slide title

2. Clamping plate with hole pattern

Button
Slide title

3. Clamping plate with positioning elements

Button
Slide title

4. Clamping plate on the supply station

Button
Slide title

5. Clamping plate with clamping modules

Button
Slide title

6. INNOCLICKER with clamped workpiece

Button

Simple clamping plates

Holes are drilled into the clamping plates and the modular positioning elements are screwed in, creating an exact 6-point-net that aligns your workpiece perfectly. Now the connectors for the hydraulic clamping modules are screwed in and your special fixture for your workpiece is ready.

If after some time you want to machine workpieces of the same type again after some time, you only have to store the plate and after clicking in the clamping modules you can start immediately without losing the reference.

The supply station

The supply station has five zero-point chucks on its upper side to fix the clamping plate. There are several pressure modules on the sides on which the maximum pressure and clamping sequence for each clamping module can be set individually. The hydraulic pressure is generated by a built-in, pneumatically operated pump. An external hydraulic pressure supply is therefore not required for operation, just connect compressed air.

Innoclicker clamping system supply station with description

Slide title

Clamping module "woodpecker"

Button
Slide title

Clamping module "supporting element"

Button
Slide title

Clamping module "linear piston"

Button
Slide title

"Linear piston" in cut view

Button

Innovative modules

Various clamping modules are available for the INNOCLICKER clamping system. Depending on the machining task and the workpiece geometry, suitable clamping modules are used to ensure distortion-free and secure clamping of the workpiece.

All clamping modules can be simply pushed onto a standardized clamping rail at the clamping plate and locked into the correct position with a "click". To disconnect the module from the clamping plate, simply press the red button on the clamping element and the module can be reinstalled in another set-up.